By Zendaya Foust. Electric Bass Guitar. Published at Friday, August 31st, 2018 - 11:57:20 AM.
That way I'm always working on one of them and they are both done around the same time. Its also good to add a coat right before you are on the way out to school, the store or work, that way it gets a nice long undisturbed drying session. Once everything is sealed, buffed and drilled, assemble the neck. I will go into further finer drilling and adjustment in another section as I know some of you will have a neck with no holes drilled, but this is a very easy extra step! After the tuners, and string trees are mounted the final step is the string nut. I have found that it is best to take this to a professional because it takes practice and a skilled hand to file the nut blank. If you mess up you have to buy another nut and uncool it off the finger board and that's a waste of time and money. It may cost a little bread but the tech can slap on a nice new custom nut and have the bass growling with new strings the same day, which is always a nice ending to a custom job well done! I would also encourage you to watch (if you can) the tech install everything and learn all you can. I know after a few questions and watching, I was able to nail this delicate step, but take your time!
This is why you want to make sure that you have a diagram that you can use, but where do you get them from? There are a number of sites online that offer you schematics for making up these types of cables, as said before it is not that hard, but you will want to make sure that you follow the instructions perfectly if you are doing to have a fast connection to use in your home or office. You will find that the cables have a very distinct color code to it. There are many different colors used in Ethernet wiring, but most of the time the common colors are used all over the world. If you are going to find the right setting for this type of thing you will want to make sure that you spend a little time online.
Below is a diagram showing how a standard P-Bass split coil pickup is wired as hum-canceling pickup. The pickups are wired in series. (For another example as having them wired in parallel, check out pickup_parallel_wiring. Notice that the split coils are actually out of phase here. It does not matter in this case that the coils are out-of-phase, since there are no other pickups here. If the coils are wired in-phase, then it becomes a single coil type of wiring, and you can expect to hear hum when your are near electrical fields. If you wish to add a J-Bass pickup in the bridge position, you will likely need to wire the P-Bass as a single coil, unless you thought ahead to by a split coil Jazz Bass pickup, as mentioned earlier.
it will gain a nice luster that will polish nicely with the wool. It is also important to remember that the neck needs to have a good amount of finish on it. This is because the neck is under constant pressure and any moisture can compromise the strength of the wood that leads to warpage. ( There are some woods that cant even take coats of like most of the African woods because they are too oily or waxy already.) I find that Tru-Oil needs a good day or two to cure which is why I always try to finish the body and the neck staggered one after the other.
Any content, trademark’s, or other material that might be found on the Pajama Music website that is not Pajama Music’s property remains the copyright of its respective owner/s. In no way does Pajama Music claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
© Copyright 2018 Pajama Music. All Rights Reserved.