Published at Friday, August 31st, 2018 - 20:39:34 PM. . By Annalise Thayer.
There are some important things here to note. First, the pickups are actually out of phase. When both pickups on a Jazz bass are turn up full on, the pickups cancel out any hum that may be in the area. If you use one coil only, it will be in single coil mode, and you can pick up hum. If you like the sound of only one coil, and hate the hum, try using a split coil Jazz Bass pickup, and wire them in hum-bucking mode. Dimarzio make these, and they are a very good sounding pickup. I have used them on previous Jazz Basses, and they work well. I especially like the adjustable magnetic pole pieces, which are easily adjusted with an Allen screw driver. Secondly, the control knobs shown (above) are wired in the Jaco Pastorious prefered fashion: Volume, Volume, Tone. The standard method is to have: Volume, Pan, and Tone.
Once the body is finished, drill holes (if needed) and assemble the body with electronics and hardware. I find after years of soldering iron burns and melted wires, as well as a trip or two to the hospital from solder fumes, that the same well vented area is needed as well as pre-assembling of the pots to the control plate be done outside and separate from the bass body itself. You want everything to be finish and connected that way the only thing left to solder will be the ground cord and pickup wires. I would also recommend buying a Jazz Bass electronic kit.
Any content, trademark’s, or other material that might be found on the Pajama Music website that is not Pajama Music’s property remains the copyright of its respective owner/s. In no way does Pajama Music claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
© Copyright 2018 Pajama Music. All Rights Reserved.