By Phoenix Girard. Electric Bass Guitar. Published at Friday, August 31st, 2018 - 22:22:29 PM.
The neck, the soul of a bass! For this bass I'm going with a maple neck and a walnut lined maple fingerboard. I like the brightness of the maple and the crazy glue epoxy finish (more on that in another section). Normally, a maple neck tends to get all gunked up with finger oil and dirt because maple tends to soil easily, however with an epoxy finish I will not need to worry about that. Again like the body, you want to make the neck smooth and supple! A 400 grit rub down with the grain works great but make sure (and I can't stress this enough) to not press hard. I order my necks unfinished so I can color and finish it anyway I want (which we will in this tutorial with Tru-Oil) plus it's way cheaper (about $50 to $80 dollars more) which really makes a huge difference especially when you are on a budget and who's not these days! Just like the body it is important to let the neck hang between coats in a well ventilated area. You will finish the neck much like the body. Use a rag and rub in small circles with the finish covering the sections of the neck. Let the neck dry an hour at a time and buff lightly with with steel wool. Again you are aiming for about 10 to 15 coats. Like on the body,
Intonation of a lined fingerboard is done in the same way as a fretted. Hook up your tuner to your bass and play the open G string in tune. Fret directly on the 12th and check to see if your fretted note is in tune. Carefully make sure that you are using the tip of your finger avoiding any kind of fingertip pivot that will change your pitch. While this is a great technique while playing, in tuning and setup its not going to do you any favors. Now if the fretted note is sharp, turn the adjustment screw on the bridge so the saddle is moving towards you. If it is flat move the saddle away from you. Do small quarter turns and bring the string back up to tune before you check it. Once the fretted note is intonated repeat the process with the other three. One thing to keep in mind is that while the fret lines are right where the frets should be, it doesn't mean that all of the lines are in tune 100% all over the neck.
They print the information into an Adobe PDF document and offer rushed service guaranteed to provide you with the diagrams for your particular car in less than 24 hours. Bulldog.com offers a basic explanation of electrical information in an MS Word document; however they do not supply charts or schematics. Two other sites that I found to offer great information were Freeauto.com and 12voltresource.com. Freeauto.com provides complete color diagnostics for most makes and models. What I found interesting(?) is freeauto will provide you these color automotive electrical charts and all the other information on their informative website for $11.99.
All the parts separately would cost a lot more, but for about 18 bucks you get them all plus instructions and trust me, wiring a jazz bass is very very easy! I will go into this in more detail in the electronics section of the website to help clear things up. Another thing I like to do helps) is to line every part of the inside of the bass with copper foil tape. This helps to ensure that even if wires do come loose they will be grounded and shielded. This also helps prevent hums picked up from lighting and other electronic devices ( lights and certain electronic devices emit a 60 cycle hum that interfere with pickups and bass electronics). Now that everything is sealed, grounded and assembled its time to move to the neck.
Any content, trademark’s, or other material that might be found on the Pajama Music website that is not Pajama Music’s property remains the copyright of its respective owner/s. In no way does Pajama Music claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
© Copyright 2018 Pajama Music. All Rights Reserved.