Published at Friday, August 31st, 2018 - 23:19:52 PM. . By Anastasia Mace.
You can do this in one of two ways. One way is to run some nice 400 grit sand paper on the fingerboard. Make sure to do this very gently because you do not want to remove the arc from your board. If you're too worried about screwing up your board spend a little cash and get your bass into a luthier to dress it for you professionally. Either way it is important that you maintain a good working fingerboard, because it's where all the sound happens. If you are lucky enough to have a bass with treated epoxy then most if not all of these maintenance steps will be unnecessary. Should problems arise make sure you do what is needed without voiding your warranty!
We will start with the body. In this tutorial we will be using a simple two piece Alder body, but like I said earlier, your tastes and budget can be the judge on what tone woods or combination you would like. The first step is to sand your new body with a 60 to 150 grit sand paper. This ensures a smooth feel, even grain and uniform look on the wood. Remember to always sand with the grain of the wood and not to push down too hard.
Any content, trademark’s, or other material that might be found on the Pajama Music website that is not Pajama Music’s property remains the copyright of its respective owner/s. In no way does Pajama Music claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
© Copyright 2018 Pajama Music. All Rights Reserved.